PLEASE REMEMBER TO MAKE YOUR CHOICE OF HOW YOU WOULD LIKE YOUR ENCLOSURE TO ATTACH TO YOUR DOORS IN THE DROP-DOWN MENU.
Enclosure for your Honda Pioneer 1000-3, sides only, uses your existing hard roof, rear window, and windshield.
Please note: If your existing rear window is a hard rear window, you will just install self-adhesive Velcro to it to attach the sides. If your existing rear window is soft, you will need to sew Velcro on it to attach the side. If you put a note in your order, we will add the sew-on Velcro at no charge.
This enclosure is made of heavy-duty ballistic material and installs easily.
Sides attach with wraps around your roll cage and across the top of your factory door with your choice of self-adhesive snaps (no drilling required), or pop rivet snaps (drilling required).
Each window unzips from the bottom allowing the door to fully open without unsnapping any snaps. The windows also unzip from the top allowing windows to open for air or just reaching out of the UTV for doing things like retrieving mail, or opening gates, etc. The entire side can be removed in seconds to allow for removal in warmer weather.
After the initial installation of setting your snaps etc., which takes less than 1 hour, the enclosure can be removed in just a minute and reinstalled in less than a minute.
It comes complete with everything needed for installation and free storage bag!
WE GIVE NO GUARANTEE ON SELF-ADHESIVE SNAPS OR VELCRO.
Please note that Velcro and self-adhesive snaps can cause damage to decals if applied over decals.
Custom made in the USA!
